Firmware Update - Bosch VideoJet 8008 Installation And Operating Manual

VideoJet 8008 / VideoJet 8004 | Installation and Operating Manual
Firmware and configuration upload

Firmware update:

The unit is designed so that its functions and parameters can be updated via
firmware. To do this, transfer the current firmware package to the unit via the
selected network. It will then be automatically installed there.
In this way, a unit can be serviced and updated remotely without a technician
having to change the installation on site.
You obtain the current firmware from your customer service or from the down-
load area on our Internet site.
Caution
Before launching the firmware update, make sure that you have selected
the correct upload file. Uploading the wrong files can result in the unit no
longer being addressable, in which case you must replace the unit.
You should never interrupt the installation of firmware. An interruption can
lead to the flash-EPROM being incorrectly programmed. This in turn can
result in the unit no longer being addressable, in which case it will have to
be replaced.
– First, save the update file to your hard drive.
– Enter the full path for the update file in the field or click Browse... to locate
and select the file.
– Next, click Upload to begin transferring the file to the unit. The progress bar
allows you to monitor the transfer.
The new firmware is unpacked and the Flash EPROM is reprogrammed. The
time remaining is shown in the message going to reset. Reconnecting in ...
seconds. The unit restarts automatically once the upload has successfully com-
pleted.
If the Fail LED then flashes, the upload has failed and must be repeated.
To perform the upload you must switch to a special page:
Bosch Security Systems | 2006-07 | V1.5
EN | 115
Configuration using a Web browser