Table of Contents
Advertisement
Camera Browser Interface
14
Network
14.1
Network Access
The settings on this page are used to integrate the device into a
network. Some changes only take effect after a reboot. In this
case Set changes to Set and Reboot.
1.
2.
The device is rebooted and the changed settings are activated.
If the IP address, subnet mask, or gateway address is changed,
then the device is only available under the new addresses after
the reboot.
14.1.1
Automatic IP assignment
If a DHCP server is employed in the network for the dynamic
assignment of IP addresses, activate acceptance of IP
addresses automatically assigned to the device.
Certain applications (Bosch Video Management System,
Configuration Manager) use the IP address for the unique
assignment of the device. If using these applications, the DHCP
server must support the fixed assignment between IP address
and MAC address, and must be appropriately set up so that,
once an IP address is assigned, it is retained each time the
system is rebooted.
14.1.2
IP V4 address
IP address
Enter the desired IP address for the camera. The IP address
must be valid for the network.
Subnet mask
Enter the appropriate subnet mask for the set IP address.
Gateway address
For the device to establish a connection to a remote location in
a different subnet, enter the IP address of the gateway here.
Otherwise, this field can remain empty (0.0.0.0).
Bosch Security Systems
Make the desired changes.
Click Set and Reboot.
Software manual
Network | en
AM18-Q0635 | v5.6 | 2013.01
99
Advertisement
Table of Contents
