Table of Contents
Advertisement
O
perations
Getting ready
1. to fill the clean/solution tank.
A. Remove the tank by lifting it
straight up and then away from the unit.
B. unscrew the black cap at the
bottom of the clean/solution tank
and remove bottle insert.
C. add bissell 2X compact formula
to the foRMula fill line (8 oz.) on the
clean/solution tank. fill the clean/
solution tank with hot (not boiling) tap
water to the WateR fill line. Replace the
bottle insert and tighten the black cap.
D. Replace the clean/solution tank by
lining up the vertical guides on the left
side of the unit with the indentations on
the clean/solution tank and gently sliding
it down into position.
2. Release vacuum flex hose by twisting the
bracket latch clockwise. unwrap vacuum
flex hose completely from around unit.
3. attach the tough stain brush tool to the
spray trigger unit by pressing tool onto
spray trigger firmly until the button lock
snaps into hole. Make certain the tool is
securely attached.
4. twist the Quick Release cord wrap clock-
wise to unwrap the power cord completely
from onboard cord storage and plug into
120 Volt grounded outlet, as described in
important safety instructions, page 3. the
heat indicator light will take 30 seconds to
illuminate.
5. Press and hold spray trigger—spray will
start in a few seconds. Raise the tool
slightly to check for spray.
6
w w w . b i s s e l l . c a
1A.
1C.
Water
formula
2.
4.
1B.
1D.
3.
5.
8 0 0 . 2 6 3 . 2 5 3 5
Hide quick links:
Advertisement
Table of Contents
