Fuel Storage - Manuell Pellet Supply; Application Options; Flue - Baxi Bioflo Installation & Servicing Instructions Manual

Pellet central heating system boiler

Hide thumbs Also See for Bioflo:

Table of Contents

Important initial information for the Technician

1.4

Fuel storage -

Pellets in bags must be stored in a dry place.

Please observe the local regulations on storing fuel.

The pellets must be transported carefully into and out of the storage room so as to maintain good

pellet quality.

BAXI Bioflo is designed for installation in the living area and is configured as a fully featured central heating sys-

tem. This means no second heat generator is required. If desired, however, BAXI Bioflo can be combined with

alternative heat generators (e.g. solar or solid fuel boiler). Refer to the hydraulic systems for details about this.

The necessary hydraulic components for a heating circuit as well as hot water preparation are integrated in

BAXI Bioflo (see hydraulic equipment). This means there is no longer any need for a boiler room or equipment

room and that BAXI Bioflo is ideally suited for use as a central heating system in houses without a basement

or when central heating is being installed in a building for the first time as part of a renovation project.

1.6

A properly dimensioned flue is required for optimal functioning of the combustion system. Measurement of the

dimensions must follow EN 13384-1. See the Technical data section for values required for this calculation.

Please note that in the lower performance range, flue gases may be below 90 °C. Therefore, thermally-insulat-

ed flues meeting thermal transmittance coefficient Group I requirements according to DIN 18160 T1 or other

appropriate, officially approved moisture-resistant exhaust systems may be connected to the hearths.

Frequently, these requirements on the flue are not satisfied during the renovation of existing systems. We there-

fore suggest an evaluation by the local building inspector before installing the boiler system. In this way appro-

priate modifications can be made to the flue before system installation. (See the technical data for flue calcu-

lation values.)

Energy-saving intake regulators or explosion flaps are not allowed to be installed in the living area.

Comply with the statutory regulations and directives.

Manual pellet supply

Table of Contents

Bioflo 12 kw pear