Installation - Alpine iXA-W407BT Owner's Manual

Installation

Caution concerning the installation location
1
Angle of installation
Install at an angle of between horizontal and 30°.
Note that installing at an angle outside of this range
will result in a loss of performance and possibly
damage.
0 -30°
2
Remove the mounting sleeve from the main unit (see
"Removal" on page 63).
Slide the mounting sleeve into the dashboard and fix
it with the metal shackles.
Mounting Sleeve
Dashboard
(Included)
Bracket key
Pressure
1
Plates*
Hex Bolt
(Included)
1
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
* The supplied face plate may be mounted.
Rubber Cap (Included)
This unit
2
Face Plate* (Included)
3
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the iXA-W407BT and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*
to the vehicle's chassis. Connect all the leads of the
iXA-W407BT according to details described in the
CONNECTION section.
2
• For the screw marked "* ", use an appropriate screw for the chosen
mounting location.
4
Slide the iXA-W407BT into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
2. Pull the unit out, keeping it unlocked as you do so.
Screw
2
*
Bolt Stud
1
*
This unit
Chassis
1
) already attached
This unit
Bracket keys
(Included)
63
-EN