Equalizer Presets (F-Eq); Setting The Response Slope For The High Range Speaker (Tw Setup); Storing Settings In The Memory; Calling Up The Preset Memory - Alpine IVA-D800R Owner's Manual

Equalizer Presets (F-EQ)

10 typical equalizer settings are preset at the factory for a variety of
musical source material.
Setting contents: F-EQ
1
Touch the title bar of F-EQ.
The F-EQ list screen appears.
2
Touch [ ] or [ ] of the desired type to set to ON.
Flat / Pops / Rock / News / Jazz&Blues / Electrical Dance /
Hip Hop&Rap / Easy Listening / Country / Classical / User1 /
User2 / User3 / User4 / User5 / User6
• Only one type can be set to ON.
• By selecting User 1 to 6, you can recall the stored preset number in
"Graphic Equalizer Adjustments (G-EQ)" (page 51) or "Adjusting
the Parametric Equalizer Curve (P-EQ)" (page 51).
Setting the Response Slope for the High
Range Speaker (TW Setup)
Depending on the response characteristics of the speaker, care should be
taken when setting the response slope of the high range speaker to
FLAT in 2.2ch (3WAY) mode (see "Adjusting the Crossover Settings
(X-Over)" on page 50), as speaker damage may result.
Setting item: TW Setup
Touch [ ] or [ ] of TW Setup to select Factory's or User's.
Factory's: As protection from possible speaker damage, FLAT
cannot be set for the response slope of the high range
speaker in 2.2ch (3WAY) mode.
User's: The FLAT setting is possible in 2.2ch (3WAY) mode.
• Only if the 2.2ch (3WAY) switch is toggled between 4.2ch (FRONT/
REAR/SUBW.) and 2.2ch (3WAY) on the IMPRINT audio processor
(PXA-H100), you can select the TW Setup mode.
52
-EN

Storing Settings in the Memory

Adjustment or setting contents of X-Over, Time Correction and P-EQ,
etc. can be stored.
Contents that can be stored vary depends on the IMPRINT audio
processor used.
1
Check whether the Defeat mode is OFF.
2
Touch [MEMORY] on the A.Processor list display.
3
Within 5 seconds, touch any one of the preset
buttons [P.SET 1] through [P.SET 6] on the
A.Processor list screen.
The setting contents are stored.
• The stored contents will not be deleted even when the battery power
cord is detached.
• This operation cannot be performed when a typical equalizer setting
(e.g. pops) is selected in "Equalizer Presets (F-EQ)" (page 52).

Calling up the Preset Memory

1
Check whether the Defeat mode is OFF.
2
Touch any one of the preset buttons [P.SET 1]
through [P.SET 6] on the A.Processor list display to
select the preset memory.
• You can adjust this setting in main source screen by touching [
directly.
• It takes a few moment to recall the preset memory.
]