Bluetooth Audio Function; Bluetooth Audio Operation; Rearview Camera Operation (Optional); Switching The Rear Camera Screen (Optional) - Alpine IVA-D800R Owner's Manual

• If the voice dial fails, the unit will return to normal mode in 30
seconds.
• You can perform this operation only when a voice dial compatible
mobile phone is connected. If the mobile phone is not compatible
with the voice dial, "Failed" is displayed for 2 seconds.
• The Voice Dial function performance depends on the recognition
range of the mobile phone and mounting location of the microphone.
Note when the microphone is mounted.
• This operation cannot be performed when the current source is
BLUETOOTH Audio.
• Voice dial operation depends on the function of the mobile phone.
For details, refer to the Owner's Manual of the mobile phone.

BLUETOOTH Audio Function

BLUETOOTH Audio Operation

Audio information of a BLUETOOTH compatible mobile phone, a
portable player, etc., is controllable/playable wirelessly* from this unit.
* To play back audio, a mobile phone or a portable player conforming
to A2DP (Advanced Audio Distribution Profile) or AVRCP (Audio/
Video Remote Control Profile) is required.
Not all functions work with all devices.
• During a call, sound on the BLUETOOTH audio source is muted.
Recalling the BLUETOOTH audio source
1
Press SOURCE/ on the unit.
The SOURCE selection screen is displayed.
2
Touch the [BT Audio] icon.
The BT Audio source is activated and the display changes
to the BT Audio main screen.
Selecting the desired Song
Touch [ ].
Returns the beginning of the song being played back.
Touch [ ].
Forwards the next song.
Pausing
[ ].
Touch /
A playback stops. Touching again will resume a playback.
Rearview Camera
Operation (Optional)
When an optional rearview camera with RCA output connector or
Direct output connector such as HCE-C107D, etc. is connected, rear
view video can be output to the monitor.
• Depending on the connected Rearview Camera, be sure to set
"Camera IN" to "Direct" or "AUX" before using the Rearview
Camera, refer to "Setting the Rear Camera Input" on page 46.
Switching the Rear Camera Screen
(Optional)
The rear view video will be displayed for the two situations as below.
Displaying the rear view video while the
car is in reverse
1
Shift the gear lever to the reverse (R) position.
The rear view image is displayed while the car remains in
reverse.
2
If you shift the gear lever to a position other than
reverse (R), the monitor returns to the previous
screen.
• Be sure to also check behind the car visually. Use the camera image
to assist in showing conditions behind the car.
• This function is effective when the reverse wire is properly connected.

Displaying the rear view video manually

1
Press SOURCE/ on the unit.
The SOURCE selection screen is displayed.
2
Touch [Camera].
The Camera mode is activated and the rear view video is
displayed.
3
Touch [Guide On] or [Guide Off] to set whether the
rear camera guide line is displayed.
4
Touch [ ] to access to Visual selection screen, and
then touch [Normal] to return to previous main
screen.
65
-EN