Paper - NEC SuperScript 750C User Manual

If you removed the paper from the ASF, you must press
PAPER, repeat the entire paper loading operation and
then press PAPER again.
Make sure the paper is not feeding in crookedly.
If the ON LINE light indicator flashes slowly, open the
cover to check the position of the print head carriage,
which may have moved to indicate a paper out condition.
Make sure the correct paper feed parameter is selected
in your printer driver, load paper in the ASF and press

PAPER .

3. Single sheets/envelopes not loaded (or loaded
incorrectly).
The document/envelope has not been positioned
correctly for insertion.
Make sure the correct paper format parameter is
selected in your printer driver.
Preprinted documents must have a clean 5 mm margin
before the first print position.
4. Paper jams or tears.
The intermittent flashing of the ON LINE light indicator
signals that a paper jam has occurred.
The most common causes of paper jamming in the ASF
are:
the addition of paper when the ASF is not empty,
36
– when adding paper to the ASF, ALWAYS remove
any paper already present and reload it all as a
single pack.
– after clearing a paper jam from the ASF or printing
area, ALWAYS remove any paper still in the ASF,
check it for and remove any damaged pages,
press PAPER and then reload the paper.
the incorrect loading of paper,
trying to load a single document through the manual
feeder when the ASF is empty or when it contains a
narrower document format than that in the manual
feeder.
If the paper has already exited from the print area:
– remove the jammed paper, pulling it carefully forward
towards the output tray.
– to resume printing, check the paper in the ASF (if
necessary remove any imperfect/damaged sheets,
fan and square it and then reload it in the ASF),
and then press ON LINE.
If the paper jams in the ASF:
– press POWER (printer off) and disconnect the printer
from the electrical power supply
– remove the damaged page(s) from the ASF. Remove
the rest of the paper, check it for imperfect/damaged
sheets, fan and square it and then reload it in the
ASF.
– Reconnect and power the printer.
Troubleshooting - Paper