Table of Contents
Advertisement
To run the setup utility, proceed as follows:
1. Insert the diskette containing the setup utility program in
drive a (usually) of your computer.
2. At the DOS prompt, type A:\ (or B:\)STUP750.EXE, and
press ENTER.
3. The program will read the setup parameters currently
stored in the printer. It will then display a screen offering
the choice:
- Print head alignment, or
- Printer setup modifications.
4. If you click Print head alignment, the program will
display a series of screens which guide you step by step
through the alignment procedure.
5. If you click Printer setup modifications, the program
will display the setup parameters currently stored in the
printer.
6. If you click Change Parameters, the parameter group
selection screen is displayed.
You can now select, one at a time, the parameter groups
containing the feature(s) you wish to change.
See also Appendix B for a complete list and description
of the parameters available.
7. If you click Factory Default, you restore the default
settings.
8. If you click Quit, you abandon the setup utility program
and return to DOS. If you changed any settings, you will
be prompted to confirm that you want to "Save setup
into printer?".
Using Software - Running the Printer Set-Up Utility
The parameter settings defined in the driver and
common to the program always have priority over the
settings made using the setup utility.
31
Advertisement
Table of Contents
