Photo Cartridge; Re-Aligning The Print Heads; Print Head Care - NEC SuperScript 750C User Manual

Hide thumbs Also See for SuperScript 750C:
Table of Contents

Advertisement

Photo Cartridge

This all-in-one print head has been developed especially for
printing photographic images. It contains water-resistant
three-color and Photo Black ink.
You should inserted the Photo Cartridge in place of the
color print head, which you must keep in the storage
container provided.
See "Paper" and "Using Software" for information on the
types of printing media to use and the installation of the
specific Photo Kit driver.

Re-aligning the Print Heads

Whenever you change the print heads, you must check their
alignment.
This operation can be done either using the Printer Monitor
in Windows® environment or the printer setup utility
program under DOS.
See the specific sections in "Quick Start" and "Using
Software".
Ink Jet Print Heads - Photo Cartridge

Print Head Care

Always keep the print heads and ink cartridges
sealed until they are to be used.
Separate the ink cartridge from the print head ONLY to
replace it. Do NOT remove and then reinsert it. The ink
cartridge replacement operation should done ONLY
when a new cartridge is available for IMMEDIATE
substitution; the print head MUST NOT be left without an
ink cartridge inserted.
Remember to remove the protective tape/capsule (point
2 in figure 2 on page VIII) before inserting the print
head/ink cartridge in the printer. Take care not to get ink
on your clothes; the ink in the cartridge stains.
Do NOT remove the cap (point 1 in figure 2 on page VIII)
from or attempt to refill a cartridge with ink, as this
damages the print head and the printer.
DO NOT shake the print head; it is not a fountain pen. If
it does not print, do the cleaning operations described in
the next section.
If you think that the number of pages printed with the
current print head/cartridge is fewer than usual, try
cleaning the print head. If the "end of ink" condition
persists, the print head/ink cartridge is empty and
requires replacing.
Always press POWER before disconnecting your printer
from the power supply or before switching off your
computer. This will guarantee that the print head
carriage returns to its rest position.
21

Advertisement

Table of Contents
loading

Table of Contents