Vertex Standard VXR-7000 Operating Manual page 14

CE27 Programming Software Instruction
DDec Type: DCS Decoder Type
This command selects the manner in which DCS is to
be decoded.
Fixed = Decodes only the type selected in above pa-
rameter (DCS Typ: Normal or Inverted).
Auto = Both types (Normal and Inverted) will be
decoded.
Double-click the left mouse button to select the desired
DCS Decoder Mode.
Multi Tone: Enable/disable Multi Tone Operation
Double-click the left mouse button to display the "Multi
Tone" window.
Double-click the left mouse button on the "Multi Tone
Enable" to toggle the Multi Tone Operation between se-
lections "yes (" ")" and "no ("
Click the left mouse button on the appropriate field to
open the "Drop Down List". Now select the desired
CTCSS tone or DCS code. You may set as many as 16
CTCSS tones and/or DCS codes.
CWID ANI/ENI: Select the Identifier mode
Double-click the left mouse button to toggle the selec-
tions "CW ID," "ANI/ENI," or "Off." To select this fea-
ture to the "CW ID" or "ANI/ENI," the "CW ID" pa-
rameter must be enabled via the dealer programming.
Action Mode: Select the repeater operation mode
Double-click the left mouse button to toggle between
"Duplex" operation or "Simplex" operation.
Tx Freq.: Edit Transmit Frequency
Use the [ 0 ] - [ 9 ] keys to enter the desired channel fre-
quency directly, and press the [ E
12
Channel Data Items
")."
] key.
NTER
CTCSS Encoders: Toggle CTCSS Encoder ON/OFF, sets
CTCSS Frequency
Double-click the left mouse but-
ton to display the "Tone Select"
window, click the left mouse
button on the desired tone, then
click the left mouse button on
the [ OK ] switch to accept the
selected tone.
DCS Encoders: Toggle DCS Encoder ON/OFF, sets DCS
Code #
Double-click the left
mouse button to display
the "Coded Select" win-
dow, click the left mouse
button on the desired
DCS code, then click the
left mouse button on the
[ OK ] switch to accept the
selected code.
Base TOT: Enable/disable the Time-Out Timer while in the
"BASE" station mode
Double-click the left mouse button to toggle the TOT
feature selects "yes" and "no."
The TOT time is determined via dealer programming.
Base Guard: Enable/disable the Base Guard Feature
Double-click the left mouse button to toggle the Base
Guard feature selects "yes" and "no."
When this parameter is set to "yes," the transmitter will
be inhibited for a few seconds before the repeater (in
the "BASE" station mode) turns to receive.
The inhibit time is determined via dealer programming.
LOUT: Select the Lock Out Feature's mode
Double-click the left mouse button to toggle the Lock
Out Feature between "BCLO," "BTLO," or "off."
"BCLO" inhibits transmitting while there is carrier
present. "BTLO" inhibits transmitting while there is car-
rier present unless there also is a valid tone present.
TX Pwr: Transmitter Power Output Selection
This parameter selects the desired power output from
the VXR-7000 on the current channel. The available val-
ues are HIGH and LOW.
Double-click the left mouse button to select "Hi" or "Lo."
VXR-7000 FM R
EPEATER
O M
PERATING ANUAL