Preparing The Components For Use; Em 100 G2 Rack-Mount Receiver - Sennheiser ew 100 G2 Instructions For Use Manual

14

Preparing the components for use

EM 100 G2 rack-mount receiver

Mounting the receiver feet
To ensure that the receiver cannot slip on the surface on which it is placed,
four self-adhesive soft rubber feet are supplied.
Ensure that the base of the receiver is clean before mounting the rubber
feet.
Fix the rubber feet to the base of the receiver by peeling of the safety
paper and fitting them as shown in the digram on the left.
Attention!
Some furniture surfaces have been treated with varnish, polish or synthe-
tics which might cause stains when they come into contact with other
synthetics. Despite a thorough testing of the synthetics used by us, we
cannot rule out the possibility of staining.
Connecting the antennas
The supplied telescopic antennas can be mounted quickly and easily to the
rear of the receiver and are suitable for all applications where – good recep-
tion conditions provided – a wireless transmission system is to be used wit-
hout a large amount of installation work.
Connect the telescopic antennas to the BNC sockets
of the receiver.
Pull the telescopic antennas
Use remote antennas when the receiver position is not the best antenna posi-
tion for optimum reception.
Connecting the mains unit
The EM 100 G2 is powered via a mains unit.
Pass the cable through the cable grip
Insert the DC connector on the mains cable into the DC socket
and
out and align the upwards in a V-shape.
.
at the rear
.