Preparing The Components For Use; Sr 300 Iem G2 Stereo Transmitter - Sennheiser 300 IEM - 12-03 Instructions For Use Manual

48

Preparing the components for use

SR 300 IEM G2 stereo transmitter

Mounting the transmitter feet
To ensure that the transmitter cannot slip on the surface on which it is placed,
four self-adhesive soft rubber feet are supplied.
Ensure that the base of the transmitter is clean and free from grease
before mounting the rubber feet.
Fix the rubber feet to the base of the transmitter by peeling of the safety
paper and fitting them as shown in the digram on the left.
Attention!
Some furniture surfaces have been treated with varnish, polish or
synthetics which might cause stains when they come into contact with
other synthetics. Despite a thorough testing of the synthetics used by us,
we cannot rule out the possibility of staining.
Connecting the antenna
The supplied telescopic antenna can be mounted quickly and easily to the
rear of the transmitter and is suitable for all applications where – good
transmission conditions provided – a wireless transmission system is to be
used without a large amount of installation work.
Connect the telescopic antenna
transmitter.
Pull the end cap to extend the telescopic antenna
Use a remote antenna (available as an accessory) when the transmitter
position is not the best antenna position for optimum transmission.
Connecting the mains unit
The transmitter is powered via a mains unit.
Pass the cable through the cable grip
Insert the DC connector on the mains cable into the DC socket
Connecting the amplifier/mixing console
Connect the amplifier/mixing console to the XLR-3F sockets
MONO) or (right).
Both balanced and unbalanced connection is possible (see "Connector
assignment" on page 73).
Note:
Any unit that is only suitable for mono operation must be connected to
XLR-3F socket . In this case, set the transmitter to mono operation via
the menu.
to the BNC socket at the rear of the
.
.
.
(left and