GBC F - 160 Operation And Maintenance Manual page 155

Applications
c) Lay the sheet of Hot Tissue on the board so the
two leading edges are aligned. Refer to Figure
6.7.3
INFORMATION
The thin line of glue will assist with
holding the layers to the board.
d) Run a thin line of glue across the leading edge of
Hot Tissue just placed on the board.
Figure 6.7.3
Thin line of glue
e) Pull the thermal laminate straight down toward
the front infeed table so that approximately 6 in.
is resting on the front infeed table. Refer to
Figure 6.7.4
Page 6 - 66
F - 160 Operation and Maintenance Manual
Figure 6.7.4 Leader board
Thermal
laminate
f) Position the leader board so that half is pressed
Print
Hot
Tissue
Substrate
g) Press STOP.
against the thermal laminate resting on the front
table. Refer to Figure 6.7.4
INFORMATION
Position the leader board squarely
onto the thermal laminate.
2.0
G O
S P E E D
S T O P
S A F E T Y
© GBC Pro - Tech August 1999
Leader
board
F W R
R E V .