GBC F - 160 Operation And Maintenance Manual page 102

F - 160 Operation and Maintenance Manual
INFORMATION
The leading edge is the first part of the
board or image that enters the nip
of the rollers.
b) Place a padded paper weight or similar object
in the center of the image to help hold the
image in place.
- If the pre coated board is larger than the
image, you must trim the board or make an incision
in the release liner so that only the desired amount
of release liner is removed. Refer to Figure 6.2.3
Caution should always be exercised
when using a knife .
Sharp knife can cut you!
Figure 6.2.3 Trim the release liner
Make a shallow cut into
the release liner
© GBC Pro - Tech August 1999
CAUTION
- If the image is larger , you must trim the image
so that no more than 1 in. exceeds the precoated
board all the way around. Refer to Figure 6.2.4
Figure 6.2.4 Trim the image
Image
Pre-coated
Board
No more than 1 in. over hang
c) Peel back about 1 in. of the release liner from
the precoated board and fold back. Refer to
Figure 6.2.5
Figure 6.2.5 Peel back release liner
Leading edge
Applications
Cut
Release liner
Pre-coated
board
Page 6 - 13