1.
Set the pressure handle to the roller release position
and raise the cover.
2.
Use a damp ( use water only to dampen the cloth )
white terry cloth towel to wipe dust from the upper roller.
3.
For the lower roller, close the cover, press RUN to
rotate the lower roller to a new area to clean.
4.
Repeat the steps above until the lower roller is cleaned
7.2.2 Adhesive on rollers
CAUTION: Hardened adhesive deposits on the
rollers can cause damage to the rollers.
CAUTION: Do NOT pick or pull heat activated
adhesive off the rolls when they are cold. You can
cause irreparable damage to the laminating rolls.
CAUTION: The following procedure is performed
while the laminator is HOT! Use extreme caution!
Page 7-2
Spartan Operation and Maintenance Manual
1.
Set the pressure handle to the roller release position
and raise the cover.
2.
With a rubber cement eraser or Scotch Brite
rub the adhesive on the roller.
CAUTION: Excessive pressure can destroy the
silicone layer by pressing too hard or scrubbing too
long in one spot.
3.
Use a damp (water only) white terry cloth towel to
wipe adhesive beads off the roller.
4.
For the lower roller, close the cover, press RUN to
rotate the lower roller to a new area to clean.
5.
Repeat the steps above until the lower roller is cleaned
© 2004 General Binding Corporation
TM
gently