Fisher & Paykel CG365CWACX1 Installation Instructions And User Manual page 22

Using your cooktop
20
US
CA
(EN)
Auto-reignition is for your convenience and safety. The auto-reignition feature causes the
ignitors to spark automatically and the burner to relight if a flame blows out or if the flame is
severely distorted by a draft or a cooktop ventilation system.
Constant sparking
The ignitors must be kept clean and dry to work
correctly. Dirty or wet ignitors could cause constant
sparking, even if a flame is present.
(See 'Troubleshooting').
Ignitors can be kept
clean with a small brush
and rubbing alcohol.
If the burner has an inconsistent flame or does not light
If the gas does not light within four seconds, turn the dial to OFF. Allow at least two minutes
for the gas to disperse before trying again.
Check that the power to the product is switched on.
Check that the burner parts are assembled correctly as below:
Correct assembly Incorrect assembly
Power failure
In the event of a power failure, turn all burner control dials to OFF. The burners can be lit by
holding a lighted match close to the side of the burner and turning the control dial to HI. Wait
until the flame is burning all the way around the burner cap before adjusting.