Removing the bezel
If you need to install or replace a 5.25-inch device or the 3.5-inch diskette
drive, you need to remove the front bezel.
Follow the ESD precautions described in "Static electricity
1.
precautions" on page 2.
Turn off the system and disconnect the power cord.
2.
Remove both side panels as described in "Removing the side panel"
3.
on page 3.
From the inside of the chassis, remove the two screws securing the
4.
bezel to the chassis. See Figure 2.
To Remove the Front Bezel
Figure 2: Removing the Bezel
System Access
5