Gateway 7400 System Manual page 130

Error message
Invalid password
Keyboard clock line failure
Keyboard controller failure
Keyboard not detected
Keyboard stuck key failure
Memory errors were detected
while the system powered up
Memory size error
Non-system disk or disk error
Not enough memory
122
Troubleshooting
Solutions
Enter your password again, making sure to
enter it correctly. Note that some passwords
are case-sensitive.
If you do not know the password, you may
need to reinstall the software you are trying to
access.
Startup passwords are stored in BIOS. If this
password has been set and is unknown, you
may be able to reset the password through
system board jumper settings.
Try a working keyboard.
Make sure the keyboard is compatible with the
system. You may have to change the switch
setting to AT.
Try a working keyboard.
Make sure the keyboard is compatible with the
system. You may have to change the switch
setting to AT.
See "The keyboard does not work." on
page 117 for a possible solution.
Turn off the system, then check the keyboard
cable.
Remove any objects that may be resting on the
keyboard, then restart the system.
Check for sticky keys. Clean the keyboard if
necessary.
See "The system detected memory errors
during start up." on page 111 for a possible
solution.
Enter the BIOS Setup utility, then save the
memory configuration.
Eject the diskette, then press E
If the diskette is bootable, check it for errors.
Close all programs that are not currently in
use.
.
NTER