Wpa-Psk/Wpa2-Psk; Mac Filter - ZyXEL Communications NBG6503 User Manual

Chapter 10 Wireless LAN

10.4.3 WPA-PSK/WPA2-PSK

Click Network > Wireless LAN 2.4G or Wireless LAN 5G to display the General screen. Select
WPA-PSK or WPA2-PSK from the Security Mode list.
Figure 62 Network > Wireless LAN 2.4G/5G> General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 34 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
LABEL
Security Mode
WPA-PSK
Compatible
Pre-Shared Key
Group Key
Update Timer
Apply
Cancel
Refer to Table 31 on page 86

10.5 MAC Filter

The MAC filter screen allows you to configure the Router to give exclusive access to devices (Allow)
or exclude devices from accessing the Router (Deny). Every Ethernet device has a unique MAC
(Media Access Control) address. The MAC address is assigned at the factory and consists of six
90
DESCRIPTION
Select WPA-PSK or WPA2-PSK to enable data encryption.
This field appears when you choose WPA-PSK2 as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to your
Router.
WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
The Group Key Update Timer is the rate at which the AP sends a new group key out to all
clients.
Click Apply to save your changes back to the Router.
Click Cancel to reload the previous configuration for this screen.
for descriptions of the other labels in this screen.
NBG6503 User's Guide