Restart Screen; System Operation Mode Overview - ZyXEL Communications NBG6503 User Manual

Table 69 Maintenance > Backup/Restore (continued)
LABEL
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default Router IP
address (192.168.1.2). See
your computer's IP address.

22.8 Restart Screen

System restart allows you to reboot the Router without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 117 Maintenance > Restart
Click Restart to have the Router reboot. This does not affect the Router's configuration.

22.9 System Operation Mode Overview

The Sys OP Mode (System Operation Mode) function lets you configure your Router as an access
point, wireless client or both at the same time. You can choose between Router and Access Point
Mode depending on your network topology and the features you require from your device.
The following describes the device modes available in your Router.
NBG6503 User's Guide
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the Router while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the Router again. The Router automatically restarts in this time causing
a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information
and returns the Router to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
Router. Refer to the chapter about introducing the Web Configurator for more information
on the RESET button.
Appendix B on page 181
Chapter 22 Maintenance
for details on how to set up
161