Client Mode; Setting Client Mode; Navigation Panel - ZyXEL Communications NBG2105 User Manual

Table 6 Navigation Panel: Access Point Mode (continued)
MENU
Status
Status
Statistics
Log

3.5 Client Mode

In Client mode, the NBG2105 acts as a wireless client to connect to an existing access point
wirelessly. It acts just like a wireless client in notebooks/computers. In Client mode:
• The IP address of the device on the local network is set to 192.168.1.2.
Figure 8 Client Mode Application

3.5.1 Setting Client Mode

Select Client Mode if your device needs a wireless client to connect to an existing access point. To
set Client mode:
Make sure the power LED is on (not blinking).
1
Slide the Operation Mode Switch to Client. See
2
The NBG2105 restarts after you slide the Operation Mode Switch.
3
To allow NBG2105 clients access to the Internet, the NBG2105 must be routed to the access point.

3.5.2 Navigation Panel

Use the sub-menus on the navigation panel to configure NBG2105 features.
NBG2105 User's Guide
FUNCTION
Use this to view system, wireless, local and WAN network information, as well as general
information about the NBG2105.
Use this to show the number of packets sent and received on the Wireless LAN and
Ethernet WAN interfaces.
Use this to look at all of the NBG2105's logs in one location.
Client
Access Point
Section 1.8 on page 16.
Chapter 3 Operation Modes
27