Access Point Mode - ZyXEL Communications NBG2105 User Manual

Chapter 3 Operation Modes
Table 5 Navigation Panel: Router Mode (continued)
MENU
MAC Filtering
Firewall
Port Filtering
IP Filtering
MAC Filtering
URL Filtering
Management
NTP
Password
Upgrade
Firmware
Backup/
Restore
Operation
Language
Reboot
Status
Status
Statistics
Log

3.4 Access Point Mode

An access point enabled all ethernet ports to be bridged together and be in the same subnet. To
connect to the Internet, another device, such as a router, is required. In Access Point Mode:
• All clients belong to the same subnet.
• All clients of the device are LAN clients. There is no WAN connection.
• The DHCP server is disabled.
• The IP address of the device on the local network is set to 192.168.1.2.
24
FUNCTION
Use this to allow or deny wireless stations based on their MAC addresses from connecting
to the NBG2105.
Use this to apply filtering based on UDP or TCP port numbers.
Use this to apply filtering based on IP addresses.
Use this to apply filtering based on MAC addresses.
Use this to apply filtering based on URLs.
Use this to change your NBG2105's time and date.
Use this to change your NBG2105's system password.
Use this to upload firmware to your NBG2105.
Use this to view information related to factory defaults, backup configuration, and
restoring configuration.
Use this to change between access point mode and router mode.
Use this to select the language you prefer.
Use this to restart the NBG2105 without turning the power off.
Use this to view system, wireless, local and WAN network information, as well as general
information about the NBG2105.
Use this to show the number of packets sent and received on the Wireless LAN and
Ethernet WAN interfaces.
Use this to look at all of the NBG2105's logs in one location.
NBG2105 User's Guide