Edimax BR-6524n Manual page 111

Remote IP Address
Remote Port Range
Traffic Type
Protocol
Please click 'save' button to save settings, and the rule you just set will
appear in current QoS table; if you did anything wrong, you'll get an
error message when you click 'Save' button, please correct your input by
the instructions given by the error message. If you want to erase all values
you just entered, click 'Reset'.
number that will be affected by this rule. If you
want to apply this rule on port 80 to 90, please
input '80-90'; if you want to apply this rule on
a single port, just input the port number, like
'80'
Specify the remote (destination) IP address that
will be affected by this rule. Please input the
starting IP address in the left field, and input
the end IP address in the right field to define a
range of IP addresses, or just input the IP
address in the left field to define a single IP
address.
Please input the range of remote (destination)
port number that will be affected by this rule. If
you want to apply this rule on port 80 to 90,
please input '80-90'; if you want to apply this
rule on a single port, just input the port
number, like '80'. If the remote (destination) IP
address and /or port number is universal, just
leave it blank.
Please select the traffic type of this rule,
available options are None, SMTP, HTTP,
POP3, and FTP. You can select a specific
traffic type for this rule, if you want to make
this rule as a IP address based rule (apply the
limitation on all traffics from / to the specified
IP address / port number), select 'None'.
Please select the protocol type of this rule,
available options are TCP and UDP. If you
don't know what protocol your application
uses, please try 'TCP' first, and switch to
'UDP' if this rule doesn't seems to work.