Installing A Secondary Battery - Gateway 450 User Manual

Installing a secondary battery

Your notebook's modular bay accepts a secondary battery. The secondary
battery charges when the notebook is connected to AC power.
Warning
To install a secondary battery:
1
If you are removing a CD, CD-RW, DVD, combination DVD/CD-RW or
diskette drive, make sure that the drive is empty.
2
Make sure that your notebook is off (not in Standby or Hibernate mode).
3
Close the LCD panel.
4
Disconnect your notebook from the optional port replicator (see
"Disconnecting from the port replicator" on page 260).
5
Turn your notebook over so that the bottom is facing up.
6
Slide and hold the bay module latch closest to the back of the notebook.
Danger of explosion if battery is incorrectly replaced.
Replace only with a Gateway 450SX4 secondary battery.
Discard used batteries according to the manufacturer's
instructions.
The battery used in this device may present a fire or
chemical burn hazard if mishandled. Do not disassemble,
heat above 212°F (100°C), or incinerate. Dispose of used
battery promptly. Keep away from children.
www.gateway.com
Changing batteries
145