Starting Program Search; Cancelling, Restarting Program Search - AOR AR5000 Operating Manual

An example of possible programming is as follows (in these
examples the mode, step etc are taken from the
AUTOMODE bandplan data):
10 118.000 to 137.000 MHz
11 225.000 to 410.000 MHz
12 410.000 to 425.000 MHz
13 156.000 to 163.000 MHz
14 88.000 to 118.000 MHz
15 145.200 to 145.775 MHz
16 433.000 to 433.600 MHz
17 1297.000 to 1298.000 MHz
18 71.000 to 87.000
19 163.400 to 225.000 MHz

12-5 Starting program search

Assuming that the AR5000 is pre-programmed with similar
data to that shown, initiate PROGRAM SEARCH by
pressing . The legends "BANK" and "
on the right of the LCD to confirm selection.
To select a specific search bank rotate the
in the two digit bank identifier via the numeric keypad.
The bank number is displayed underneath the legend
"BANK". The numeric keypad may also be used while in
search mode to change bank.
For example, to search bank "
in search mode, there is no need to press enter.
The lowest frequency in the bank will first appear on the
LCD and will change in an upward direction. Use the
keys or
of search.
Should the receiver stop on an unwanted active frequency,
press the or
force the search process to continue.
Note: Bank numbers "
zeros. Banks " " to "
the preceding " " is automatically added by the AR5000
microprocessor. Banks "
both (two) digits.
Example:
To select bank 0 (00) press
To select bank 1 (01) press
To select bank 5 (05) press
To select bank 9 (09) press
To select bank 10 press
To select bank 19 press
PAGE 50 AR5000 OPERATING MANUAL
MHz
" appear
or key
" press
to reverse the direction
keys or rotate the
" and " " require preceding
" just need the last digit keyed,
" to " " require the entry of
The key
may also be selected as
action of some TV & video remote controls.
12-6 Cancelling, re-starting program
search saving active frequencies
It is possible to cancel program search, resume, save
frequency to VFO where it may be tuned, save frequencies
to memory and more...
Cancelling search
To cancel program search press
return to whichever VFO was last used (
, ). If you resume program search (by pressing
), the process will continue from the frequency in
use when cancelled.
Restarting search
If you resume program search by pressing
process will continue from the frequency in use when
cancelled. If however you wish to restart program search
process from the original frequency it is necessary to
re-select the bank. This can be done by clicking the
one step then back or by keying in the bank
number again.
while
Accept the frequency from program search mode
If you wish to stop the program search and monitor an
interesting busy frequency, it is necessary to transfer the
desired frequency to VFO-D where it may be monitored
without the search process starting as the frequency clears.
To transfer the frequency press
is busy. The frequency will be transferred to VFO-D and
the legend "
LCD to confirm operation.
to
Saving busy frequencies into memory
It is possible to save interesting frequencies into memory.
While stopped on an active frequency press and hold the
key for more than one second. The MEMORY
INPUT menu will appear. Select the desired memory
location for storage (refer to section 7-1 of this manual if
you are unsure of the required key strokes). When the
is pressed to accept input, the program search
process will resume.
has the effect of a TEN key, i.e. bank 13
in a similar way to the
while the frequency
" will be displayed on the lower right of the
, the display will
, , ,
, the