Threading The Lower Thread (Looper Thread) - JUKI MEB-3810 Instruction Manual

(2) threading the lower thread (looper thread)

For the model provided with
the needle thread clamp unit
1. When passing the looper thread, turn looper bracket by 180 degrees of an angle in advance.
2. In the case of the overall thread trimmer type machine, pass the looper thread through the nee-
dle hole in the throat plate and allow the looper thread clamp to clamp it. then, start sewing.
In the case of the needle thread trimmer type machine, allow the thread trimmer retaining
plate to clamp the looper thread and gimp. then, start sewing.
If thread waste is clamped by the looper thread clamp or the thread trimmer retaining plate, re-
move it. If sewing is carried out when the thread waste remains clamped by either of them, the
looper thread cannot be clamped properly, resulting in stitch skipping at the beginning of sewing.
Needle thread trimmer type
Looper thread
thread trimmer retaining plate
– 33 –
Gimp