Lte Policy Configuration - Cisco ASR 5x00 Home eNodeB Administration Manual

▀ HeNB-GW Service Configuration
end
Notes:
 <
dest_ctxt_name
tunnel over IuPS interface towards core network.
 <
gtpu_svc_access
towards S-GW or core network. This service has to be associated with the HeNB-GW Access Service in case
S1-U Relay is enabled.
 <
gtpu_svc_network
This service has to be associated with the HeNB-GW Access Service in case S1-U Relay is enabled.

LTE Policy Configuration

Use the following example to configure the LTE Policy. Othe rconfigurations done under this config include MME pool
and tracking area information list (TAI list) database.
configure
lte-policy
mme-pool <mme_pool_name> -noconfirm
mme <mme-name> ipv4-address <ipv4_addr> sctp port <sctp_port_no>
exit
tai-list-db <lte_policy_tai_db>
tai mcc <mcc_id> mnc <mnc_id> tac <tac_code1> <tac_code2> <tac_code3>
exit
end
Notes:
 <
mme_pool_name
 <
mme-name
 <
ipv4_addr
 <
sctp_port_no
 <
lte_policy_tai_db
 <
mcc_id
 <
mnc_id
 <
tac_code1
one line.
▄ Cisco ASR 5x00 Home eNodeB Gateway Administration Guide
42
> is name of the destination context in which GTP-U service configured to provide GTP-U
> is name of the GTP-U service configured to provide GTP-U tunnel over S1-U interface
> is name of the GTP-U service configured to provide GTP-U tunnel over towards HeNB.
> is a string of size 1 to 63, which configures a specified MME pool.
> is a string of size 1 to 63, which configures a specific MME.
> is the remote SCTP IP address for S1 association to configured MME.
> is the SCTP port which is an integer ranging from 1 to 65535.
> is the tracking area information list database, which must be a string of size 1 to 64.
> is a three digit number between 100 to 999.
> is two/three digit number between 00 to 999
> is the tracking area code value ranging as a integer from 0 ... 65535. Up to 256 can be defined on
HeNB-GW Service Configuration Procedures