Cisco ASR 5x00 Home eNodeB Administration Manual page 36

▀ Information Required to Configure the System as an HeNB-GW
Required Description
Information
Public Land Mobile Country Code (MCC): The MCC can be configured to any integer value from 0 to 999.
Mobile Network
Mobile Network Code (MNC): The MNC can be configured to any integer value from 0 to 999.
(PLMN) Identifiers
Macro eNodeB ID Macro eNodeB identifier, required as a parameter for the Logical eNodeB configuration. It is an option to
the Home eNodeB identifier.
Home eNodeB ID Home eNodeB identifier, required as a parameter for the Logical eNodeB configuration. It is an option to
the Macro eNodeB identifier.
S1-MME interface IPv4 addresses assigned to the S1-MME interface as SCTP bond address. This address will be used for
IP address binding the SCTP (local bind address(es)) to communicate with the MME using eGTP. The HeNB-GW
passes this IP address during setting up the association with the MME.Multiple addresses and subnets are
needed if multiple interfaces will be configured.
S1-MME SCTP The physical port to which is used to communicate with the HeNBs over S1-MME interface. It is usually an
Port integer value ranging from 1 to 65535.
Logical eNodeB Configuration
MME Pool A pre-configured MME pool to be associated with the Logical eNodeB. An MME pool is configured in the
LTE Policy Configuration Mode. Only one MME Pool instance can be associated with a Logical eNodeB
instance. All MMEs in the pool are assumed to support all TAIs in the associated TAI List DB object. One
Logical eNodeB can connect up to 8 MMEs and therefore a max of 64 associations can be established
between HeNB-GW and MME
TAI List DB A pre-configured list of tracking area identity (TAIs) pool to be associated with the Logical eNodeB. A TAI
List database is configured in the LTE Policy Configuration Mode. Only one TAI list DB can be associated
with the Logical eNodeB instance. The tai-list-db contains a list of TAIs. These are sent in the S1 Setup
message to the MME to indicate the list of TAIs supported by the eNodeB. The TAI database which can be
associated to each logical EnodeB can accommodate 256 configuration of TACs.
TAI List DB Configuration
MCC Mobile Country Code (MCC): The MCC can be configured to any integer value from 0 to 999.
MNC Mobile Network Code (MNC): The MNC can be configured to any integer value from 0 to 999.
Tracking Area TAC is an integer value rainging from 0..65535. The HeNB-GW Network service searches these TACs for
Code (TAC) establishing UE connections.
▄ Cisco ASR 5x00 Home eNodeB Gateway Administration Guide
36
HeNB-GW Service Configuration Procedures