Henb-Gw Service Configuration - Cisco ASR 5x00 Home eNodeB Administration Manual

▀ HeNB-GW Service Configuration

Step 12
Specify the SCTP port for the S1-MME interface bound in Step 11.
Step 13
Configure the MME Group Identifier for the HeNB-GW Access service. As part of this configuration, group ID as well
as the MME code has to be configured. MME ID is used as part of S1 setup procedure during HeNB association. It is an
integer value ranging from 0 to 255.
Step 14
Associate the HeNB-GW Network service configured in the step 4 to this HeNB-GW Access Service.
Step 15
Configure the Public Land Mobile Network Identifiers MMC and MNC for this HeNB-GW Access Service.
Step 16
Enable the S1-U Relay for this HeNB-GW Access service. Using this step, the user enters in the S1-U Relay
Configuration Mode. This is an optional step.
Step 17
Associate the Access and Network GTP-U services created in the Step 3 to this HeNB-GW Access service. Association
of the GTP-U services is mandatory in case S1-U Relay is enabled.
HeNB-GW Service Configuration
Use the following example to configure the HeNB-GW service on system in source context to provide access to HeNBs
towards core networks:
configure
------------------ Context Configuration --------------------
context <ingress_ctxt_name>
----------- Interface and IP addresses Configuration -----------
interface <interface_name>
ip address <ipv4_addr> 255.255.255.0
ip address <ipv4_addr> 255.255.255.0 secondary
exit
-------- Access and Network GTP-U Services Configuration ------
gtpu-service <gtpu_svc_access> -noconfirm
bind ipv4-address <secondary1_ipv4_addr>
exit
gtpu-service <gtpu_svc_network> -noconfirm
bind ipv4-address <secondary2_ipv4_addr>
exit
------------- HeNB-GW Network Service Configuration -----------
henbgw-network-service <henb_network_svc_name> -noconfirm
▄ Cisco ASR 5x00 Home eNodeB Gateway Administration Guide
38
HeNB-GW Service Configuration Procedures