GE EGR3000 Owner's Manual & Installation Instructions page 46

Before you call for service...
Troubleshooting -tips
Possible Causes What To Do
"LOCK DOOR"flashes The self-cleaJ_ cycle has been * Close tile oxen (loo_:
in the display selected but the door is not
closed.
LOCKEDDOOR light
The oven door is locked
is on when you want
because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
• Touch tile CLEAR/OFFpad. _Mlow tile oven to cool and
then, on models with a door latch, tmh)ck tile dora:
Oven door will not Oven is too hot. • _Mlow the oven to cool below h)c!dug temperature.
unlock (on models Do not lock the door with the door latch except when
with a doorlatch) usiuo the sell=clean feature,
"Ooor"appears
in the Self-clemahag cycle has been • Move the latch handle all the way to the fight,
display (on models selected but the latch handle
with a door latch) was not moved all the way
to the fight.
Latch handle was moved to the
• Move the latch handle
to the right only when
,settiw,
right but a program other than the sell:cleaning cycle.
self-clemth_g was selected.
"T--and a number or On models with a door latch, • The latch may have been moved, even if (rely slightly,
letter"flash in the display if a fmaction error code appears fi'om the h>cked position. Make sure the latch is moved
during the self-clemlhlg cycle, to the right as flu" as it will _o
check the oven door latch.
You have a function error code. • Touch the CLEAR/OFFpad, ?dlow the oven to cool for
()lie hot/r, Put the oveu
back
iuto operatiou.
If the function code repeats. • Discouue(t ;Ill power to tile range for 5 minutes
;lud then
l'eCouuect powel:
If tile
hluctiou erl'Ol"
code repeats, call fin" service.
Display goes blank A fuse in your holne may be
• Replace
tile fllSe o1"reset flw circuit breakel:
blm_ or the circuit
breaker tripped.
The clock is in the • See tile Special features of your oven controlsectiou.
black-out mode.
Display flashes
Power failure.
• Reset the dock.
Unable to get the Oven control pads were • The BAKE mad BROIL H!/LO pads must be touched at
displayto show "SF" not touched properly, flw same time mad held fin" 3 seconds.
Power outage, Power outage or surge. • Reset the clock./f the oven was in use rot! must reset
it by touching the CLEAR/OFFpad, ,settiu,_ the clock and
resetting
a uy c()()king flmcti(m.
Oven shelves are
The nickel shelves (if so equipped)
difficult to slide were demzed in a self-cleml cycle.
The gray porcelain-coated shelves
(if so equipped) were improperly
clemzed.
• Apply a small am(rout of vegetnble oil to a paper
towel and wipe tile edges of tile oven shelves with
tile paper
towel. Do not spray with Pare _ or other
lul)ficant spra)s.
46