Select Connection Mode Dialog Box; Performing Data Communication Between The Classpad And A Personal Computer - Casio fx-CP400 User Manual

Wakeup
Wakeup is a function that automatically puts the ClassPad into data communication standby whenever the
ClassPad detects data coming in from an external device connected to the 3-pin port of the ClassPad. When
the sending device performs a data send operation, the receiver device's wakeup function activates and data
receive is performed automatically. The receiver device operates normally as long as no data is being received.
Note that wakeup does not operate on the receiver device when any ongoing calculation or graphing operation
is being performed. Wakeup activates when the ongoing operation is complete.
Communication Application Menus and Buttons
• Select data to send ........................................................................................................Link - Transmit or E
• Enter receive standby .....................................................................................................Link - Receive or R
• Enter standby for operating system upgrading .................................................................... Link - OS Update
• Configure communication parameters ................................................................... Setup - Open Setup Menu
• Start up Variable Manager ..........................................................................................................................5

Select Connection Mode Dialog Box

Connecting ClassPad to a computer or projector with the USB cable will cause
the Select Connection Mode dialog box shown nearby to appear. Tap the
button that corresponds to device that ClassPad is connected to.
USB Flash: Mode for connecting ClassPad to a computer for data transfer. See
"Connecting and Disconnecting with a Computer in the USB Flash Mode" (page
251) for details.
Screen Receiver: Mode for using the Screen Receiver software*
computer running Windows Vista, Windows 7, Windows 8 or Mac OS, which
displays ClassPad screen contents on the computer screen.
Screen Receiver(XP): Mode for using the Screen Receiver software*
which displays ClassPad screen contents on the computer screen.
Projector: Mode for connecting ClassPad to a projector and projecting ClassPad screen contents. See
"Projecting ClassPad Screen Contents from a Projector" (page 258) for details.
Cancel: Closes the Select Connection Mode dialog box without changing the setting.
*1 See the Screen Receiver User's Guide for details. Do not perform any operation on ClassPad until the
ClassPad screen contents are displayed by Screen Receiver.
Tip
• Instead of tapping on-screen buttons, you can also use the keypad keys 1 through 5 to select a connection mode.
• The Select Connection Mode dialog box will not appear right away if you connect the USB cable while a progress bar is
displayed or while a calculation is in progress. Disconnect the USB cable and wait until the progress bar disappears or the
calculation is complete, and then reconnect.
15-2 Performing Data Communication between the
ClassPad and a Personal Computer
You can perform the following operations when connected to a computer.
Transfer data between the ClassPad and a computer
Variable data and eActivity data, as well as VCP and XCP files (page 253) can be transferred between the
ClassPad and a computer.
1
on a
1
on a computer running WindowsXP,
Chapter 15: Performing Data Communication 250