Transmitting A Message - Icom VHF IC-F50 Insrtuction Manual

5
MDC 1200 OPERATION
D Transmitting a Message
The transceiver can send a pre-programmed message to the dis-
patcher. There are 16 messages that can be sent on a channel.
q Push [MDC Call] to enter the MDC menu selection mode.
w Select "MSG" using [CH Up], [CH Down], [MDC Up] or [MDC
Down].
e Push [MDC Call] again to enter the pre-programmed message
selection mode.
r Select the desired message using [CH Up], [CH Down], [MDC
Up] or [MDC Down].
t Push [PTT] to transmit the message to the dispatcher.
• "MSG TX" is displayed.
y Release [PTT].
• "MSG OK" is displayed.
• "MSG FAIL" is displayed if there is no acknowledgment from the
dispatcher.
u After a specified time period has passed, the transceiver will re-
turn to receive.
39
Pre-programmed message is displayed.