Mode - Olivetti ECR 2300 Instructions Manual

Pr Pr Pr Pr Programming Manager P ogramming Manager P ogramming Manager P ogramming Manager Passw ogramming Manager P
You can define two individual manager passwords to prevent
unauthorized access to the machine's programming mode (PRG), Z
mode and X mode. One manager password grants access to the PRG
and Z modes, while another grants access to the X mode.
Def Def ining a PRG and Z Mode Manager P ining a PRG and Z Mode Manager P
Def Def Defining a PRG and Z Mode Manager P ining a PRG and Z Mode Manager P ining a PRG and Z Mode Manager Passw
Proceed as follows to define a manager password that grants access to
the PRG and Z modes:
1. Turn the PRG key to the PRG position.
2. Type [111111] and press the [Amt Tend/TOTAL] key. The message
"P Z PASS" appears on the displays.
3. Type your 4-digit manager password and then press the [Non Tax]
key.
NOTE: If you define a manager password of 0000, the password
security protection feature will not work.
Example: Define manager password 9876 for the PRG and Z modes.
Type/Press:
[111111] + [Amt Tend/TOTAL] + [9876] + [Non Tax]
28
asswor or or or ords assw assw assw ds ds ds ds
asswor or or or ord d d d d assw assw
assw
Def Def ining an X Mode Manager P ining an X Mode Manager P
Defining an X Mode Manager P Def Def ining an X Mode Manager Passw ining an X Mode Manager P
Proceed as follows to define a manager password that grants access to
the X mode:
1. Turn the PRG key to the PRG position.
2. Type [222222] and press the [Amt Tend/TOTAL] key. The
message "X PASS" appears on the displays.
3. Type your 4-digit manager password and then press the [Non Tax]
key.
NOTE: If you define a manager password of 0000, the password
security protection feature will not work.
Example: Define manager password 7654 for the X mode.
Type/Press:
[222222] + [Amt Tend/TOTAL] + [7654] + [Non Tax]
Using the Cash Reg Using the Cash Register in a P Using the Cash Reg ister in a P ister in a P ister in a Passw
Using the Cash Reg Using the Cash Reg ister in a P

Mode

Mode Mode
Mode Mode
If a manager password was defined to protect unauthorized access to
the PRG, Z and X machine modes, proceed as follows to enter the
specific passwords so that you can work normally in these modes:
1. Turn the PRG key to the PRG, X or Z position.
2. Type the specific 4-digit password that grants you access to the
required mode.
3. Press the [Check] key.
NOTE: If you attempt to use a protected machine mode without typing
the correct password, the cash register emits an error signal
and the message "PSEC ERR" or "X SECERR" appears on the
displays.
asswor or or or ord d d d d assw assw
assw
asswor or or or ord Pr assw assw d Pr d Protected d Pr otected otected otected
assw d Pr otected