Panasonic GT01 User Manual page 119

Code No. Content
SD memory card
**1002
memory full
SD memory card
**1003
reading error
SD memory card
**1005
saved file name error
SD memory card
**1006
recognition error
PLC model unmatch
**1020
error
PLC model
**1021
unsupported error
Password protection
**1022
error
Master memory
**1023
installation error
General-purpose
**1025
memory shortage
**1027 Remote mode error
**102D Forced operation error
**1040
**1041
The record area for
logging was
overwritten.
**1042
**1044
SD memory card
**1043
writing error
The record area for
logging cannot be
**1045
reserved in the
SRAM.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Cause and solution
Data cannot be written as the memory of the SD memory card
has been exhausted. Delete some data in the SD memory card
or prepare a new SD memory card.
The data in the SD memory card cannot be read.
Check whether the saved data in the SD memory card is not
damaged with a PC.
The file name to be saved to the SD memory card from the GT
is not specified properly. Specify the file name properly.
The SD memory card cannot be recognized.
Check the SD memory card used.
Check if the PLC program for transfer matches the destination
PLC.
The selected PLC model is not supported. Confirm the PLC
model.
(1) Incorrect passwords were input three times or more. Input
the correct password after turning the power supply off and then
on again.
(2) The upload protection has been set for the PLC.
(3) The number of digits was changed when setting a new
password with the FP monitor function. Cancel the password
setting first to change the number of digits.
A master memory is installed in the PLC (FP-X).Programs
cannot be transferred to the PLC with the master memory from
a SD memory card.
General-purpose memory shortage in the destination PLC.
The PLC (FP2/FP2SH) is set to the RUN mode. Change to the
REMOTE mode or PROG. mode.
Check if a device that cannot be forcibly operated in the PROG.
mode has been forcibly turned on or off.
A SD memory card is not inserted.
Check the SD memory card slot.
Data cannot be written into the SD memory card. Check whether
the SD memory card is not write-protected.
As the memory of the SD memory card has been exhausted.
Delete some data in the SD memory card or prepare a new SD
memory card.
The setting to stop writing to SD memory card has been set.
Cancel the writing stop setting.
The setting to stop writing to SD memory card has been set.
Cancel the writing stop setting.
Transfer all data.