Decoded Obs Setting; Radial From Active Vor; Radial From Standby Vor; Panel. - Garmin Apollo SL30 COMM Installation Manual

Nav/comm transceiver
Hide thumbs Also See for Apollo SL30 COMM:
Table of Contents

Advertisement

Serial Interface Specifications
D
OBS
ECODED
This message outputs the current OBS setting, which may be read from an external resolver or
from user input to the front panel. After power up this message will be sent at a 10 Hz rate.
Message format:
"V".................Message class. This is a VHF NAV message.
"22"................Message identifier.
v .....................Valid flag. "0" = OBS invalid/not present, "V" = OBS setting is valid.
ddd .................Three digit OBS setting, in degrees. Values are in the range of "000" to
Example message:
$PMRRV22V170<chksm><CR><LF>
A valid OBS setting of 170 degrees.
R
F
A
ADIAL
ROM
This message outputs the current bearing from the active VOR station. This message will be
output even when a localizer is being tracked by the NAV receiver. In this case, the bearing will
be marked as invalid. After power up this message will be sent at a 10 Hz rate.
Message format:
"V".................Message class. This is a VHF NAV message.
"23"................Message identifier.
v .....................Valid flag. "0" = bearing not valid, "V" = bearing is valid.
dddf ................Bearing to a resolution of 1/10
Example message:
$PMRRV23V1654<chksm><CR><LF>
A valid bearing of 165.4 degrees FROM the active VOR station.
R
F
S
ADIAL
ROM
This message outputs the current bearing from the standby VOR station. This message will only
contain valid data when the standby frequency is a VOR and the unit is in monitor mode. This
message will be output even if valid data cannot be provided. In this case, the bearing will be
marked as invalid. After power up this message will be sent at a 1 Hz rate.
Message format:
"V".................Message class. This is a VHF NAV message.
"24"................Message identifier.
72
SETTING
"359".
VOR
CTIVE
degrees, ranging from "000" to "359". f = 1/10
VOR
TANDBY
th
of a degree. ddd = three digit bearing in
th
of a degree.
Apollo SL30 Installation Manual

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Apollo sl30 navApollo sl30

Table of Contents