ZyXEL Communications P-334U User Manual page 106

P-334U/P-335U User's Guide
Table 35 PPTP Encapsulation
LABEL
Password
Retype to Confirm
Nailed-up Connection
Idle Timeout
PPTP Configuration
Get automatically from
ISP
Use Fixed IP Address
My IP Address
My IP Subnet Mask Your ZyXEL Device will automatically calculate the subnet mask based on the
Server IP Address
Connection ID/
Name
WAN IP Address Assignment
Get automatically from
ISP
Use Fixed IP Address
My WAN IP
Address
Remote IP Address Enter the remote IP address (if your ISP gave you one) in this field.
Remote IP Subnet
Mask
Metric
Private
DNS Servers
106
DESCRIPTION
Type the password associated with the User Name above.
Type your password again to make sure that you have entered is correctly.
Select Nailed-Up Connection if you do not want the connection to time out.
This value specifies the time in seconds that elapses before the ZyXEL Device
automatically disconnects from the PPTP server.
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Select this option If the ISP assigned a fixed IP address.
Type the (static) IP address assigned to you by your ISP.
IP address that you assign. Unless you are implementing subnetting, use the
subnet mask computed by the ZyXEL Device.
Type the IP address of the PPTP server.
Type your identification name for the PPTP server.
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Select this option If the ISP assigned a fixed IP address.
Enter your WAN IP address in this field if you selected Use Fixed IP Address.
Enter the remote IP subnet mask in this field.
This field sets this route's priority among the routes the ZyXEL Device uses.
The metric represents the "cost of transmission". A router determines the best
route for transmission by choosing a path with the lowest "cost". RIP routing
uses hop count as the measurement of cost, with a minimum of "1" for directly
connected networks. The number must be between "1" and "15"; a number
greater than "15" means the link is down. The smaller the number, the lower
the "cost".
This parameter determines if the ZyXEL Device will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept private and
not included in RIP broadcast. If No, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
Chapter 6 WAN