Wps Station Screen - ZyXEL Communications NBG4604 User Manual

Chapter 7 Wireless LAN
Table 32 Network > Wireless LAN > WPS
LABEL
Status
Release
Configuration
Apply
Refresh

7.9 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this
screen, click Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 52 Network > Wireless LAN > WPS Station
94
DESCRIPTION
This displays Configured when the NBG4604 has connected to a
wireless network using WPS or when Enable WPS is selected and
wireless or wireless security settings have been changed. The current
wireless and wireless security settings also appear in the screen.
This displays Unconfigured if WPS is disabled and there are no
wireless or wireless security changes on the NBG4604 or you click
Release_Configuration to remove the configured wireless and
wireless security settings.
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security
settings for WPS connections on the NBG4604.
Click Apply to save your changes back to the NBG4604.
Click Refresh to get this screen information afresh.
NBG4604 User's Guide