Resetting The Nbg4604; Procedure To Use The Reset Button; Navigating The Web Configurator; Status Screen (Router Mode) - ZyXEL Communications NBG4604 User Manual

Chapter 3 The Web Configurator

3.4 Resetting the NBG4604

If you forget your password or IP address, or you cannot access the Web
Configurator, you will need to use the RESET button at the back of the NBG4604
to reload the factory-default configuration file. This means that you will lose all
configurations that you had previously saved, the password will be reset to "1234"
and the IP address will be reset to "192.168.1.1".

3.4.1 Procedure to Use the Reset Button

Make sure the power LED is on.
1
Press the RESET button for longer than 1 second to restart/reboot the NBG4604.
2
Press the RESET button for longer than five seconds to set the NBG4604 back to
3
its factory-default configurations.

3.5 Navigating the Web Configurator

The following summarizes how to navigate the Web Configurator from the Status
screen in Router Mode and AP Mode.

3.6 Status Screen (Router Mode)

Click on Status. The screen below shows the status screen in Router Mode.
30
NBG4604 User's Guide