Status Screen (Ap Mode) - ZyXEL Communications NBG4604 User Manual

Chapter 5 AP Mode
To set your NBG4604 to AP Mode, go to Maintenance > Sys OP Mode >
2
General and select Access Point.
Figure 25 Maintenance > Sys OP Mode > General
A pop-up appears providing information on this mode. Click OK in the pop-up
3
message window. (See
pop-up.) Click Apply. Your NBG4604 is now in AP Mode.
Note: You have to log in to the Web Configurator again when you change modes.

5.3 Status Screen (AP Mode)

Click on Status. The screen below shows the status screen in AP Mode.
Figure 26 Status Screen (AP Mode)
56
Section 22.4 on page 197 for more information on the
NBG4604 User's Guide