Preparing The Camera And Decorative Cover For Side Cable Exit; Installing The Camera - Panasonic WV-CS580/G Installation Manual

 Preparing the Camera and
Decorative Cover for Side Cable Exit
The camera and decorative cover should be prepared
as shown below when mounting the camera on a
ceiling or wall with its cables (power, video output,
RS485, alarm in, alarm out) exiting from the side.
Perform this task when using Ceiling Mount Bracket
WV-Q126, or Wall Mount Bracket WV-Q118.
The camera mounting base needs to be removed in
order to prepare the camera. See steps 1 and 2 below
for information about how to remove the camera
mounting base.
* Prevent the dome cover from being scratched by
placing it on a soft cloth while you are working.
Preparing the Camera Case*
Preparing the Decorative Cover
Important:
• When using Ceiling Mount Bracket WV-Q126
(option), or Wall Mount Bracket WV-Q118
(option), cut only the camera case. Do not use
decorative covers on these mount brackets.
 Installing the Camera
• Select an installation location that is strong enough
to withstand the total weight of the camera.
Installing the camera at a location that is too weak
can cause it to fall.
• Remove the dome protective sheet after the
installation work is complete.
• If you are using an optional bracket to install the
camera, install the bracket in accordance with the
instructions that come with it.
1. Remove the fixing screw (M3 × 6) that secures the
camera to the camera mounting base.
Put the screw in a place where it will not become lost.
Note:
• If the camera mounting base is hard to be
removed, after loosening the screw, press
upwards on the camera and then remove it.
Break it off
with a pair
of pliers.
Cut it off
Fixing screw
2. Rotate the camera mounting base unit in the
direction indicated by the arrow and remove it.
Rotate
3. Using the camera mounting base as a template, mark
the locations of the four mounting holes on the ceiling.
If you are using the top cable exit configuration, mark
the location of the cable hole on the ceiling and drill
the hole.
For the direction of the camera mounting base,
please refer to the following figure.
The direction of the front of the camera
4. Affix the camera mounting base onto the ceiling.
Use screws (M4) at the locations you marked above
to secure the camera mounting base to the ceiling.
If you do not plan to install the camera right away,
affix the dust protect sheet to the camera mounting
base to keep dust off of it.
Important:
• Screws: locally procured.
15°
Pull the camera
mounting base
up to remove it.
Cable hole
Ø35 mm
Screws
(M4, available separately)
Dust Protect Sheet
17