Panasonic WV-CS580/G Installation Manual page 10

Screw tightening
 The screws and bolts must be tightened with an
appropriate tightening torque according to the
material and strength of the installation area.
 Do not use an impact driver. Failure to observe
this may cause overtightening and consequently
damage to the screws.
 When a screw is tightened, make the screw at a right
angle to the surface. After tightening the screws or
bolts, perform visual check to ensure tightening is
enough and there is no backlash.
When the screw is not needed, it should be removed
and stored in an appropriate location.
Note:
• If needed, please complete grounding before
connecting the power plug. Likewise, the power
plug should be unplugged before ending the
grounding.
• The camera does not have a power switch. The
camera will turn on automatically when the power
cord is attached to the main lead. After starting,
the self-cleaning function will be automatically
activated, as will the pan, tilt, zoom and focus
actions.
Check before connection
Compatibility of devices are restricted. Before
connections, check the ratings and dimensions of the
devices to be used.
Contact your dealer for details.
Important hints to help with the installation
A self-cleaning function is activated (PAN/TILT/ ZOOM/
FOCUS) when this product is turned on.
Heat radiation
The surface of this product radiates heat. Ventilation
holes should be provided when installing the camera in
an enclosed ceiling or confi ned location where heat can
build up.
10
Ventilation holes