Simulator Mode - Garmin GPSMAP 192C Owner's Manual

Simulator Mode

Simulator Mode turns the GPS receiver off for use indoors or
practice. Any of the functions discussed in the following pages
can be performed in Simulator Mode. While in Simulator Mode, a
"Running Simulator" message appears after 2 minutes of inactivity.
Keep in mind that the GPSMAP 192C does not track satellites in
Simulator Mode, and this mode should never be used for actual
navigation. All the waypoint and route planning completed in
Simulator Mode is retained in memory for future use.
NOTE: Do not attempt to navigate using Simulator Mode.
When the unit is set to Simulator Mode, the GPS receiver is
turned off. Any satellite signal strength bars displayed are only
simulations and do not represent the strength of actual satellite
signals.
GPSMAP 192C Owner's Manual
To place the GPSMAP 192C in Simulator Mode:
1. Press MENU twice to display the Main Menu. Press Up or
Down on the ROCKER until the GPS tab is highlighted,
then press MENU.
2. Use the Up or Down arrow of the ROCKER to highlight
Start Simulator and press ENTER. Choose No to the retail
demonstration and press ENTER.
3. Press ENTER to confirm the Running Simulator message
that appears at the bottom of the display. Simulating
appears at the top of each of the Main pages.
4. To turn off the Simulator Mode, press MENU, and select
Stop Simulator.
B O > S M
ASIC PERATION IMULATOR ODE
3