Replacing The Air Filter Element - Yamaha YZF-R1R Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
15. Install the radiator cap and the
coolant reservoir cap, and then
start the engine and let it idle for
several minutes. During this peri-
od, rev the engine two or three
times between 3,000–5,000 r/min,
and then turn it off.
16. Remove the radiator cap to check
the coolant level in the radiator. If
necessary, add sufficient coolant
until it reaches the top of the radia-
tor, and then install the radiator
cap.
17. Check the coolant level in the res-
6
ervoir. If necessary, remove the
coolant reservoir cap, add coolant
to the maximum level mark, and
then install the cap.
18. Start the engine, and then check
the vehicle for coolant leakage. If
coolant is leaking, have a Yamaha
dealer check the cooling system.
19. Install the cowlings and the panel.
1. Bolt
Replacing the air filter
element
The air filter element should be re-
placed at the intervals specified in the
periodic maintenance and lubrication
chart. Replace the air filter element
more frequently if you are riding in un-
usually wet or dusty areas.
1. Remove the rider seat. (See page
3-15 for rider seat removal and in-
stallation procedures.)
2. Remove the bolt.
6-21
1. Fuel tank breather hose
2. Fuel tank overflow hose
EAU04572*
3. Lift the front of the fuel tank, and
then tilt it back and away from the
air filter case. (Do not disconnect
the fuel hoses!)
WARNING
_
G Make sure that the fuel tank is
well supported.
G
Do not tilt or pull the fuel tank
too much, otherwise the fuel
hoses may come loose, which
could cause fuel leakage.
_
4. Disconnect the fuel tank breather
hose and the fuel tank overflow
hose.
EW000071