Rear Wheel - Yamaha YZF-R1R Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Axle nut
2. Drive chain slack adjusting bolt
3. Locknut

Rear wheel

To remove the rear wheel
6
WARNING
_
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
_
1. Loosen the axle nut and the brake
caliper bolts.
2. Lift the rear wheel off the ground
according to the procedure on
page 6-44.
1. Bolt (× 2)
2. Brake caliper
3. Brake caliper bracket
3. Remove the axle nut, and then re-
EAU04915
move the brake caliper by remov-
ing the bolts.
EW000122
CAUTION:
_
Do not apply the brake after the
brake caliper has been removed,
otherwise the brake caliper pistons
will be forced out.
_
4. Loosen the locknut on each side of
the swingarm.
5. Turn the drive chain slack adjust-
ing bolts fully in direction a.
6-47
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
NOTE:
_
ECA00146 The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
_