Rear Wheel - Yamaha PW50 2020 Owner's Manual

Periodic maintenance and adjustment
3. Insert the wheel axle from the right
side.
4. Install the washer and axle nut,
and then tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
36 N·m (3.6 kgf·m, 27 lb·ft)
5. Connect the brake cable at the
wheel hub, and then install the
brake lever free play adjusting nut.
6. Adjust the brake lever free play.
(See page 7-17.)
7. Take the motorcycle off the cen-
terstand so that the front wheel is
on the ground.
8. Push down hard on the handlebar
several times to check for proper
fork operation.
7

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Place the motorcycle on the cen-
terstand.
2. Remove the seat. (See page 4-8.)
3. Remove the muffler bolt and
washers. WARNING! Always let
the exhaust system cool prior to
touching exhaust components.
[EWA14582]
4. Slide the spring clamp down, and
then remove the muffler.
1. Muffler
2. Washer
3. Muffler bolt
4. Spring clamp
5. Remove the exhaust chamber bolt
and washers.
7-24
EAU25081
EAU56822
EWA10822
4
1 2 3