Scrub Motor - Windsor COMDU Operator Instructions Manual

Scrub Motor

Do not use a pressure washer to clean around the
brush motors. Use tap pressure only.
To Replace Scrub Brush Motor
1. With the scrub deck in the lowered position,
remove the deck cover and disconnect brush
motor wiring connector from harness.
2. Remove the motor and end bracket assembly from
the deck.
3. Separate brush motor from end brackets.
4. Reverse to reassemble.
Brush Motor Carbon Brush Replacement
1. Scribe alignment mark on motor barrel to motor
2. Remove end cap from motor.
3. Release brush from spring tension. Remove screw
4. Retract spring and install new brush. Install
5. When all new brushes are installed. Place all in
6. Carefully place end cap onto bearing on motor
7. With end cap in partially installed position, release
8. Reset end cap and realign with scribe marks on
9. Maintain alignment between motor barrel base and
86292200 COMMODORE DUO
cap. Remove two bolts.
NOTE: Motors contain two wave washers in cap. Do
not lose these.
connecting brush wire lead to brush holder. Clean
brush holder to insure free movement.
connector screw and lead.
retracted position, held into brush holder by spring
tension.
shaft.
NOTE: Use care to assure wave washer alignment.
all brushes to contact position with motor commu-
tator.
NOTE: Failure to insure all brushes are released will
result in motor failure.
motor barrel. Reinstall the two attach bolts from
cap into base.
cap.
Maintenance
31