Emptying And Cleaning Solution Tank; Emptying And Cleaning Recovery Tank - Windsor COMDU Operator Instructions Manual

Operations
SOLUTION
DRAIN
HOSE

Emptying And Cleaning Solution Tank

1. Park the machine next to a floor drain. Drain hose
is at the rear of the machine.
2. Turn the machine power off.
3. Remove the top of the hose from the barb mount
and lower hose in direction of the drain. Do not
stand in front of end of hose. Solution will come out
with force.
4. Remove the front cover and solution fill cover.
5. Flush the solution tank out with clean water and
run several gallons of clean water through both
spray jet systems. Do not use water hotter than
140°F (60°C) to clean tank or damage may occur.
6. Replace the drain hose to the barbed fitting.
7. If machine is to be stored, leave the solution fill
cover off.
22
Emptying And Cleaning Chemical Tanks
And System (Deluxe)
1. Turn off machine and remove front cover.
2. Park the machine next to a floor drain. The tanks
are located at the front of the machine.
3. Remove the cap and straw from each chemical
bottle and install the closed caps.
4. Remove the tanks by lifting off the solution fill
tower.
5. The chemical can remain in the tank or be
disposed of properly. Remove one cap at a time
and properly dispose of chemical. Rinse tanks with
clean water.
6. Rinse the chemical system by putting the straws
and caps in clean water. Push the prime/flush
switch for 30 seconds in each direction, "A" and
"B".

Emptying And Cleaning Recovery Tank

1. Park the machine next to a floor drain. Drain hose
is at the front of the machine.
2. Turn the machine power off.
3. Remove front cover. Remove hose assembly from
mounting hook. Place the end of the hose at the
drain and slowly remove the cap. Do not stand in
front of hose end. Soiled solution will come out
with force.
4. Remove dome lid.
5. Flush the recovery tank out with clean water. Do
not use water hotter than 140°F (60°C) to clean
tank or damage may occur.
6. Replace the drain hose cap and place hose back
on hook. Replace front cover.
7. If machine is to be stored, leave the recovery dome
off.
86292200 COMMODORE DUO