To Begin Scrubbing; To Stop Scrubbing - Windsor COMDU Operator Instructions Manual

To Begin Scrubbing

When operating the machine around people, pay
close attention for unexpected movement. Use
extra caution around children.
1. Turn machine power on.
2. Position rotary switch to the position matching the
process to be preformed, and the chemical that
was added to the solution tank or chemical tank
(Deluxe), either interim or interim/pre-spray
(Deluxe) or extraction/cleaning.
3. Check position of reverse button and the position
speed control knob so that the machine is set to
travel in the direction and the speed intended.
4. Drive machine forward by pressing either throttle
switch to begin scrubbing.

To Stop Scrubbing

1. While scrubbing turn off the pump switch to stop
2. Allow the throttle switches to return to neutral.
3. Rotate the selector switch to the accessory
4. Turn the rotary switch to the off position by rotating
Deluxe
1. While scrubbing turn off the pump switch to stop
2. Allow the throttle switches to return to neutral.
3. Rotate the selector switch to the accessory
4. Turn the rotary switch to the off position by rotating
FOR SAFETY: Before leaving or servicing
machine: stop on level surface, turn off machine
and remove key.
FOR SAFETY: When using machine, go slow on
inclines and slippery services.
86292200 COMMODORE DUO
spraying solution. Continue to scrub and recover
the solution for an additional pass.
position so that the vacuum motor continues to run
and evacuate the system. This will also raise the
deck and vacuum shoes.
the selector switch clockwise. Turn machine power
off.
spraying solution. Continue to scrub and recover
the solution for an additional pass.
position so that the vacuum motor continues to run
and evacuate the system. This will also raise the
deck and vacuum shoes.
the selector switch clockwise. Turn machine power
off.
Operations
21