Operations; Preparing The Machine For Use - Windsor Lighting 1.022-322.0 Operator Instructions Manual

PREPARING THE MACHINE FOR USE

NOTE: Before using any type of powered equipment, proper safety dictates you should visually inspect it.
1. Adjust the HANDLE to a comfortable height and tighten the bolts.
2. BONNET FILTER - Make sure the bonnet air filter atop the engine is clean. It should be changed hourly
and thoroughly cleaned before reuse.
3. Check the engine OIL LEVEL. Screw the dipstick in to get a accurate reading.
4. Fill the tank following the instructions (see "Refilling and Storing Propane Tanks." section)
5. PAD AND PAD HOLDER - Inspect the condition of the pad and pad holder for wear and correct
attachment. Ensure pad is clean and has at least a thickness of 1/3 inch. ALWAYS turn off engine to
clean or replace pad.
6. TANK and FUEL LINES – Check for any sign of wear and tear, such as cracks or any corrosion. Replace
hoses or correct any problems before operating the machine.
7. Screw the brass fuel line fitting onto the tank service valve hand tight only. This connection MUST be
secure because the service valve has a safety valve inside it which will only open if the brass fuel line
fitting is COMPLETELY seated into the service valve.
86343970 18HP LIGHTNING BURNISHER
OPERATION
2-1